Product Trade Name: ATP ASSEMBLY LUBE #AT-201
MATERIAL SAFETY DATA SHEET
(Revision Date: 05/07/2009)
|
| |
|
Section 1 PRODUCT AND COMPANY IDENTIFICATION
|
Company Identification
Life Automotive Products, Inc.
500 Industrial Park Drive
Selmer, TN 38375-3276
United States of America
Emergency Response
North America: CHEMTREC (800) 424-9300 after 5:00pm CST
Or (703) 527-3887
Health Emergency
USA: (800) 264-6457 or (731) 645-4972
Product Information
MSDS Requests: (800) 264-6457 or (731) 645-4972
Technical Information: (800) 264-6457 or (731)645-4972
General Information: vswedley@spectrumcorporation.com
| Product Family |
Petroleum Lubricating Oil |
| CAS Number |
Mixture |
Note: Petroleum lubricating oils with a flashpoint above 200°F, are not regulated by D.O.T standards. |
| |
|
Section 2 COMPOSITION / INFORMATION ON INGREDIENTS
|
|
COMPONENTS
|
CAS Number
|
Concentration (%)
|
Regulatory Agency
|
Exposure Limit
|
|
Antiwear Additive
|
Confidential
|
<2
|
OSHA
|
5mg/m3
|
Alkyl acid phosphate |
68307-94-8 |
<2 |
OSHA |
5mg/m3 |
Amines, Soya alkyl, ethoxylated |
61791-240 |
10-15 |
OSHA |
5mg/m3 |
Zinc dialkyl dithiophosphate |
Xi; R36/38 |
<0.5 |
OSHA |
5mg/m3 |
Branched Alkanes |
68649-11-6 |
10-15 |
OSHA |
5mg/m3 |
Benzotriazole derivative |
Confidential |
<0.5 |
|
5mg/m3 |
Polyalphaolefins |
Mixture |
30-40 |
OSHA |
5mg/m3 |
Petroleum distillates |
64742-54-7 |
30-40 |
OSHA |
5mg/m3 |
Viscosity Modifier (PPD) |
Mixture |
3-5 |
OSHA |
5mg/m3 |
C.I. Slvent Red 164 Red Dye* |
See Below |
<0.05 |
OSHA |
5mg/m3 |
|
*2-Naphthalenol (Phenylazo) Phenyl Azo Alkyl Derivatives. TSCA Accession #35371
Note that the chemical identity of some or all of the above components is considered confidential business information and is being withheld as permitted by 29CFR 1910.1200 and various State Right-To-Know Laws.
| HMIS/NFPA RATINGS: |
| Health: |
Flammability: |
Reactivity: |
Protective Equipment: |
| 1 |
1 |
0 |
C,D |
See Section 6, Chronic Effects, for potential over-exposure hazard.
CAUTION:
Hot oil can cause thermal burns on contact.
Used motor oil has been associated with skin cancer in laboratory animals following extended contact.
Spills may create a slipping hazard. |
|
Section 3 PHYSICAL DATA
|
|
Boiling Point
|
Not Determined
|
| Vapor Pressure (mm Hg) |
Less than 0.01 mm Hg @ 20°C |
| Vapor Density (air=1) |
Greater than 5 |
| Solubility in Water |
Negligible; less than 0.1% |
| Appearance and Odor |
Red /Mild, bland petroleum odor |
| Specific Gravity (H2O=1) |
0.8581 @ 60°F |
| Evaporation Rate |
Not Determined |
| Viscosity @ 100 |
7.2 cSt (typical) |
|
| |
|
Section 4 FIRE AND EXPLOSION HAZARDS
|
| FLAMMABLE PROPERTIES: |
| Flash Point: |
270°F |
| Extinguishing Media: |
Use water spray, dry chemical, foam or carbon dioxide. Water or foam may cause frothing. Water spray may be used to flush spills away from exposures. Use supplied-air breathing equipment for enclosed or confined spaces, or as otherwise needed. |
| Special Firefighting Procedures: |
Cool exposed containers with water spray. Avoid breathing gasses, vapor, fumes, or decomposition of products. Self-contained breathing equipment chemical resistant clothing recommended. |
| Unusual Fire and Explosion Hazards: |
Pressure increase in over heated closed containers. Cool containers with water spray. |
|
PROTECTION OF FIRE FIGHTERS:
Fire Fighting Instructions:
For fires involving this material, do not enter any enclosed or confined fire space without proper protective equipment, including self contained breathing apparatus. |
|
Section 5 REACTIVITY DATA
|
| Stability: |
Stable |
| Incompatibility: |
Avoid strong oxidants |
| Polymerization: |
Will not occur |
| Thermal Decomposition: |
Partial burning produces fumes, smoke and carbon monoxide. |
|
|
|
|
Section 6 HEALTH HAZARD DATA
|
| IMMEDIATE HEALTH EFFECTS |
|
| Inhalation: |
Inhalation of fumes may result in dizziness, headache and respiratory irritation. |
| Eye Contact: |
Contact with eyes may cause minimal irritation. |
| Skin Contact: |
Mild irritation may occur with prolonged or repeated contact. |
| Ingestion: |
Not determined. |
| TLV: |
Not determined. |
| Chronic Effects: |
Ingredients of this product are not listed as potential carcinogens in N.T.P. Annual Report on Carcinogens, I.A.R.C. Monographs, or by O.S.H.A. HCS (g) (2) (vii). |
|
| |
|
Section 7 SPECIAL PROTECTION INFORMATION
|
| Ventilation Procedure: |
Ventilate as needed to comply with exposure limit. |
| Gloves Protection: |
Use impervious gloves to avoid repeated/prolonged skin contact. |
| Eye Protection: |
Use goggles/face shield to avoid eye contact. |
| Work/Hygienic Practices: |
If clothing becomes contaminated, change to fresh clean clothing. Do not wear until thoroughly laundered. |
|
| |
|
Section 8 SPILL OR LEAK PROCEDURES
|
| Spill Procedures:
|
Remove ignition sources. Recover Liquid. Add absorbent to spill area. Ventilate confined spaces. Advise authorities if product enters sewers, etc.
|
| Waste Disposal:
|
Assure conformity with applicable disposal regulations. Dispose of absorbed material at approved waste site.
|
|
| |
|
Section 9 SPECIAL PRECAUTIONS:
|
Precautionary Measures:
Do not get in eyes, on skin, or on clothing. Do not taste or swallow. Wash thoroughly after handling.
General Handling Information:
Avoid contaminating soil or releasing this material into sewage and drainage systems and bodies of water.
General Storage Information:
Keep container closed when not in use. Do not store with strong oxidizing agents. Do not store at elevated temperatures.
Container Warnings:
Empty containers retain product residue (solid, liquid, and/or vapor) and can be dangerous. Do not pressurize, cut, weld, braze, solder, drill, grind, or expose such containers to heat, flame, sparks, static electricity, or other sources of ignition. They may explode and cause injury or death. Empty containers should be completely drained, properly closed, and promptly returned to a drum reconditioner or disposed of properly. |
| |
|
Section 10 FIRST AID MEASURES
|
| Skin: |
Wash skin with soap and warm water. Wash clothing before re-use. |
| Eye: |
If splashed into eyes flush eyes with clear water for fifteen (15) minutes or until irritation subsides. If irritation persists, call a physician. |
| Inhalation: |
The vapor pressure is very low. Vapor inhalation under ambient conditions is normally not a problem. If overcome by vapor from hot product, immediately remove from exposure and call a physician. If breathing is irregular or has stopped, start resuscitation; administer oxygen, if available. If overcome by oil mist, remove from further exposure until excessive oil mist condition subsides. |
| Ingestion: |
If ingested, do not induce vomiting. Call a physician. |
|
| |
|
Section 11 REGULATORY INFORMATION
|
| Cal. Prop. 65 |
This product contains the following chemical(s) known to the state of California to cause cancer and/or birth defects based on maximum impurity levels of components: 0.1155ppm benzene CAS no 71-43-2, 0.00006% Toluene CAS no 108-88-3 |
The data presented herein is based upon tests and information, which we believe to be reliable. However, users should make their own investigations to determine the suitability of the information for their particular purpose.
|
| |